System enclosure: Plastic housing, degree of protection: IP 65
System enclosure dimensions: 260 x 260 x 85 mm (W x H x D)
Weight: approx. 1.5 kg
Mains voltage: 115 / 230 V/AC, 48-63 Hz
Power consumption: 10 VA (without metering technology)
Display: via large-area graphical display 100 x 30mm
Operation: Plain text menu with buttons
Language: Language selection
Operating temperature: 5 to +40 °C
Storage temperature: -20 to +65 °C
Rel. humidity: max. 90% at 40 C°, non-condensing
Safety monitoring:
  • Input dosing stop (e.g. flow sensor)
  • Monitoring measuring water flow
  • Collective alarm / alarm relay
  • Alarm display on the screen in plain text
  • Flashing display illumination to indicate an alarm condition
  • Dosing time monitoring
Interfaces:
  
RS 485: for connection to dinowin / Profibus gateway / etc.
dinotecNET+: for connection to dinotecNET+ as a field device
Redox measuring amplifier:
  
Measuring range: -1500mV to +1500mV
Resolution: 1 mV
Ambient temperature influence: 50ppm/K (12mV)
Reference temperature: 23 °C
Input resistance: > 1012 Ohm
Redox measurement: via dip-type measuring chain without drainage system
Calibration: not required
pH measuring value amplifier:
  
Measuring range: -1500mV to +1500mV
Resolution: 0.01 pH or 1 mV
Ambient temperature influence: 50ppm/K (12mV)
Reference temperature: 23 °C
Input resistance: 1012 Ohm
Calibration pH: Optional one-point or two-point calibration
Electrode test: automatically after calibration
Temperature compensation of the pH value: can be set automatically or manually via PT1000
Temperature:
  
Temperature input for sensor: PT1000
Measurement range: 0 to +60 °C (+/-1%)
Inputs/outputs, control behaviour:
  
Control response: Selectable P, PI or PID control
Control: Optional 1-point or 2-point control
Binary outputs: 4 volt-free output relays for chlorine, lower pH and raise pH (pulse length, pulse frequency, on/off), alarm
Alternatively to raising pH: Flocculation dosing On/Off
Maximum contact load (230V AC): 370W (inductive), 500W (resistive load)
Maximum switching current: 30V/10A, 115V/0.3A, 230V/0.12A
Digital inputs: Empty alarm chlorine, pH lowering, dosing stop
Analogue output: 0(4)-20mA for single measured value (optional)
Conductor cross-section terminal block: 0.25 - 2.5mm²

Suche / Search

Sprache / Language

Products

Login Form